V11 video lesson
Chapter 1 · Know Your V11
Identify your exact portable unit, build its owner record and establish the safe operating boundary before setup.
V11 Training Library
Learn the complete V11 workflow in order.
Begin with the five chapter briefings. Build skill through the operating library. Finish with care, troubleshooting and a client-ready standard.
V11 Owner Start
Five chapter briefings with Maya Rose
Watch each briefing at the start of its chapter, then complete the matching written lessons and evidence checkpoints before continuing.
V11 video lesson
Chapter 2 · Prepare and Connect Your V11
Prepare the power, cartridge and companion-app path in a deliberate order without guessing across models.
Read the accessible transcript →V11 video lesson
Chapter 3 · Build Your V11 Design Library
Create a rights-safe, customer-ready design workflow through the dedicated V11 companion-app experience.
Read the accessible transcript →V11 video lesson
Chapter 4 · Complete Controlled V11 Prints
Move from readiness checks to positioning and controlled practice results while preserving safe clearance.
Read the accessible transcript →V11 video lesson
Chapter 5 · Protect Quality and Build Momentum
Use evidence-first care, support and first-week review habits to protect repeatability and owner confidence.
Read the accessible transcript →Operating library
V11 operating and quality lessons
Use these demonstrations and written competencies after the matching chapter briefing. Verify current instructions for the exact unit before acting on a physical difference.
V11 video lesson
01 · Meet your portable printer
Identify the owner controls, connection workflow and safe operating boundary.
V11 video lesson
02 · Connect your phone
Pair a supported phone or tablet and verify the companion-app connection.
V11 video lesson
03 · Install the SM10 cartridge
Confirm, handle and seat the supported cartridge without touching protected surfaces.
V11 video lesson
04 · Run the first test print
Create and document a controlled output check before printing a nail.
V11 video lesson
05 · Calibrate a print
Use the portable camera view and supported calibration control for repeatable alignment.
V11 video lesson
06 · Print from start to finish
Move from design selection and positioning through output, inspection and finishing.
V11 video lesson
07 · Test and clean the cartridge
Use a measured test-and-care sequence and stop before repeated or forceful cleaning.
Build client-ready consistency
Complete five consecutive acceptable practice prints and record products, timing and result.
Use support if the unit differs →Completion standard
Demonstrate a repeatable, documented service
Complete the sequence without unsafe shortcuts, record five consistent practice results and be able to explain every safe stop point.
Operate
Start, connect, test and position through the supported owner workflow.
Control quality
Use one-variable comparisons and record products, timing, design and output.
Protect the system
Open, close, care and escalate without forcing or opening service-only areas.
Next milestone